jnroil.blogg.se - Nanovna 2

If it is not working properly, please try again.

Thank you for your cooperation.ĭownload NanoVNA-F_FW_v1.0.2_for_HW2.2.zipĭownload NanoVNA-F_FW_v1.0.2_for_HW2.3_HW3.1.zip It is recommended to use touch pen to click the screen on time, then slide slowly to the center of cross and release it. This firmware is only applicable to NanoVNA-F machines manufactured by BH5HNU.Īny third-party NanoVNA-F hardware has not been tested, and any problems with third-party hardware using this firmware will not be explained by BH5HNU. This firmware does not apply to NanoVNA-F V2, NanoVNA-F and NanoVNA-F V2 are two independent products.If your previous version is 1.0.0/1.0.1, you do not need to perform recalibration data for this upgrade.Do not power off or unplug the type-C cable during the upgrade process!!!.However, only HCXQS is supporting the original developers. S-A-A-2 design is open source, which means anyone can manufacture it.

The linearity and dynamic range are improved. S-A-A-2 does not use harmonics it uses 2x ADF4350 to cover up to 3GHz.

Put all the files into the root directory of the disk, and then power off and power on the unit again, and the unit will be upgraded automatically. S-A-A-2 is a completely new design not based on the original NanoVNA by ttrftech.

Modify the color of the "SWEEP POINTS" mark to yellow.

Optimize the resistance touch screen calibration logic to improve accuracy.

The following new features are added: Firmware v1.0.2 update instructions: Hello everyone, we have just released NanoVNA-F firmware 1.0.2